Installations
Cultivated turf allows you to enjoy a lawn of instant beauty and maturity without the usual time-consuming hassles of seeding. When buying turfgrass sod, consult a Sodbusters® associate in your area to be assured that you are getting the finest quality turf available.
The following are the basic steps to a beautiful lawn. Check with your local Sodbusters® office for any further recommendations for your specific area.
STEP 1 - Measuring and Ordering
With a tape, measure the area of your planned lawn. Include these measurements on a sketch of the lawn area, with the length, width, and any unusual features. Your local Sodbusters® associate will be happy to determine the amount of turfgrass sod you will need from your sketch.
Schedule your order for delivery of turf after preparatory work is completed and you are ready to install. Prompt installation on the day of delivery is crucial to a strong beginning for your lawn.
Benefits of Proper and Complete Soil Preparation:
- Improved Uniformity
- Increased Density
- Faster recovery from wears
- Reduced Use of Water, Fertilizer, & Chemicals
- Reduced Maintenance
STEP 2 - Soil Preparation
There is no better time to enhance a lawn's ultimate beauty and success than by improving the soil before any planting takes place.
STEP 3 - Turf Installation
Install your lawn immediately upon delivery. Begin watering lawn within 30 minutes of installation. Turf is a living plant that requires ground contact and moisture to survive! In hot weather, protect unlaid turf by placing stacks in shade, covering with moist burlap sacking, and/or sprinkling.
Begin installing turf along the longest straight line, such as a driveway or sidewalk. Butt and push edges and ends against each other tightly, without stretching. Avoid gaps or overlaps. Stagger the joints in each row in a brick-like fashion, using a large sharp knife to trim corners, etc. Avoid leaving small strips at outer edges, as they will not retain moisture. On slopes, place the turf pieces across the slope.
Installing The Turfgrass to avoid causing indentations or air pockets avoid repeated walking or kneeling on the turf while it is being installed or just after watering. After installing the turf, roll the entire area to improve turf/soil contact. Don't Forget To Roll out and remove air pockets.
STEP 4 - Watering
Give your new lawn at least 2 to 3 cm. (1 in.) of water within 1/2 hour of installation. Water daily, or more often, keeping turf moist until it is firmly rooted (about 2 weeks). Then less frequent and deeper watering should begin.
Weather conditions will dictate the amount and frequency of watering. Be certain that your new lawn has enough moisture to survive hot, dry, or windy periods. Water areas near buildings more often where reflected heat dries the turf.
Caution: During the first three weeks, avoid heavy or concentrated use of your new lawn. This gives the roots an opportunity to firmly knit with the soil, and insures that the turf will remain smooth.
STEP 5 - Enjoy
Your new sod lawn increases your property value significantly. With proper care, it will remain a great asset, providing beauty, a clean playing surface, and an improved environment.
